Embedded electronics,
built to specification.
KBI designs, qualifies and manufactures control and instrumentation hardware for industrial automation and aerospace & defence programmes — from schematic and prototype through qualification test and rate production, under one roof.
Systems built for demanding environments.
Every assembly is engineered against a written environmental and reliability specification and produced under configuration control, so the unit you qualify is the unit you receive.
Full-authority digital control electronics for combustion and drive systems, built for closed-loop fuel and ignition management.
Solid-state and hybrid switching modules that route, protect and monitor power across critical subsystems.
Real-time embedded processing platforms with deterministic timing for closed-loop control in constrained volumes.
Rugged data-acquisition modules that capture, timestamp and store sensor readings in demanding operating environments.
Non-contact sensing modules for object detection, positioning and collision avoidance in automated systems.
High-precision laser rangefinding electronics for accurate distance measurement across industrial and field applications.
Design, test and production under one roof.
Engineering, test and manufacturing sit in the same facility, which keeps design intent intact from schematic to shipped hardware. Every unit that leaves us is traceable to its components, its operator and its test data.
Concept & requirements
Interface control, environmental and safety requirements captured and agreed up front.
Design & prototype
Schematic capture, PCB layout, firmware and bench validation ahead of formal design review.
Qualification test
Environmental, EMI and reliability testing against the programme specification, with reports.
Production & support
Rate production with full traceability, plus long-term sustainment and spares support.
An engineering house, not a catalogue.
Kamal Brand Industry trades as KBI and is led by its sole proprietor, Sohail Ahmed, from Wah Cantt, Rawalpindi. We work with customers who need control and measurement hardware to a written specification rather than an off-the-shelf part number.
Work is taken from requirement to qualified hardware in-house, so the team that draws the schematic is the team that tests, builds and supports the unit in service.
Start a conversation with our engineering team.
Tell us about your platform and requirements and we will come back with a technical response and an indicative quotation.
Wah Cantt, Rawalpindi
Punjab, Pakistan
Facility visits by appointment